SafeTrade maintains a large register of plumbing & heating engineers and our plumbers have come across many questions and queries over the years. The list below summarises the most common tips and queries we are being asked along with some best practice on energy preservation and cost savings.

    * Once a week run hot water down the drain this will keep the drain free flowing  
    * Repair leaky taps while the leak is small. It is normally simpler and cheaper to deal with a small leak rather than the result of a major leak that was left unresolved  
    * Tubs and showers drains should be fitted with strainers that catch hair and soap chips. Clean the strainers regularly.  
    * To remove unsightly mineral deposits on your shower head, put one cup of vinegar in a plastic bag and place it over the shower head. Hold it in place with a twist tie and let stand overnight. In the morning, remove the bag and wipe off the mineral deposits with a damp cloth.  
    * Do not use your toilet as a wastebasket. Do not flush facial tissue, sanitary products or diapers as they do not dissolve and can clog the lines. Keep a rubbish container in each bathroom.

Shower Head Tips

If the showerhead gets clogged, the spray becomes uneven due to the mineral deposits inside. In order to clean the showerhead, we recommend:

    * Unscrew swivel ball nut - you will need adjustable wrench or channel‑type pliers. (Hint: to protect the finish from scratches, first wrap the jaws of the tool with masking tape.)   
    * Unscrew collar nut from showerhead.   
    * Gently clean the outlet and inlet holes of the showerhead using a thin wire.   
    * Flush the head with clean water.  
    * You may want to soak the showerhead in vinegar overnight to remove all mineral deposits.  

Testing the Toilet for Leaks

    * Check the water level in the tank to be sure that the water is not overflowing by way of the overflow pipe (the pipe in the middle of the tank with a small piece of tubing connected to it).  
    * If water is running into the overflow pipe, adjust the fill valve until the water stops approximately one inch below the top of the overflow tube (there may be a water level mark stamped on the side of the tank).  
    * Test the flush valve mechanism by putting a few drops of food colouring into the tank.  
    * Check the bowl after 15 minutes, if the water has changed colour, the ball or flapper is leaking and needs to be replaced.

For a list of the Plumbing and Heating Engineers on our register please follow the link below:

SafeTrade Registered Plumbers